Speed Passion V3 Timing
 

The setup sheet made by a club pro says to use 10deg of timing, should I run 0deg of timing for the first run?

To change timing what do i actualy twist? the end cap or the black piece inside?

remove the 3 screws holding the can together (2mm hex driver). remove the sensor end cap. the sensor will be stuck to the rubber thingy. loosen it off that and put the end cap back on and replace the screws loosely. then you should be able to twist the timing around.

you may be able to loosen the sensor off the rubber without removing the end cap

Hi bud!

Have you tried the above you mentioned???
Did you notice a difference doing it?
Mine havnt got as much top end as id like and not really compareable to the x12s ive just sold...slow!!!

the sp speedos can do the timing electronicaly but i dont think you had them geared no were near were you should have

Yea I was running it on full timing yesterday and it was balistic! Proably one of the quickest cars on the straight, i just need to learn to handle the extra power! :thumbsup: