Faskolor airbrush
 

I've had a loan of a faskolor F1 airbrush.

It turns out to be a really nice brush, it sprays fine or wide just by removing a bezel on the tip and is really easy to purge all the gooey fastkolor paint out of it.

This was what I painted.
http://img.photobucket.com/albums/v2...Picture129.jpg

If thats mine Craig, you're a bloody star!!!!!:) :) :) :) :D :D :D :D , Orange goes with the Jeep Toooo!

Flippin eck Andy, that only took you 3 minutes to spot that:D

I hope you like pink aswell? LOL

Verrrrrrrrry Niiiiiiccccceeeee!!!!! Might go for orange wheels too? Don't fancy cutting the bugger out now tho.
Is that you're car you're on about on the screen?
Thanks a million!!

Will look good with white, yellow or orange wheels. I picked up a tip on cutting shells last year, a few northerners were using a dremmel with a sanding wheel. At first I scoffed at the idea but it works great!

Yeh, that is my car on my screen, she sits a lot lower than that now tho;)

Fiesta looks good, i'll try and find my bm coupe pics that were in redline, Same colour as shell!!! Candy pink;) . Now an Orange jeep, Whats next?????? perlescent Lime green m3 me thinks.
Thanks again for the shell, i gota go, weekend catching up on me:eh?: .

Craig that look fantastic!!

How did the faskolor paint do going through the brush?
No clogging or anything? and does it still look a bit rough when you try to do fine lines?

Faskolor is always clogging my badger.

I was able to use the paint a little thicker than normal without any worry about it blocking. I did find that when doing a lot of fine lines that the paint would start to dry on the end of the needle, it would then start to splatter a little, this is rectified but dragging your finger nail over the end of the needle (which is totally exposed when in fine line setup) and then a quick flick of the brush to full blast and you away again.

I especially like the way you can just load the Faskolor bottle straight onto the airbrush.

I can't remember if it is a gravity or suction need airbrush??

She's a sucker :o :D

I'm just using a Faskolor airbrush & Faskolor paints, but having a bit of trouble getting it to fine line. Is it just turning the end bit round or completely removing it? What air pressure are you using?

Id say remove the tip flare, itll allow a finer set up possibly, and allow access to the needle tip. As for pressure i shoot faskolor at 12 to 15 psi and it works fine through my Iwata and Aztek, hope that maybe helps a little.

lee

Sorry how rude of me lol, great paint bodypaint, seriously nice job:cool:

lee

I remove the end piece completely.

I run at 40psi and thin the paint a little with a IPA/H2O mix about a cap full per bottle should suffice.

Right now get yor arse in gear and do my new shells;) :p

I have to fix the piece I broke first.. oops

ipa/h2o ????? i guessed on the water bit and also did you just use the fast colour sealer to seal it all ??

isopropanol alcohol = IPA

I use halfords clear laquer, faskoat is a good sealer but a pain to spray as it's so thick.

Thanks for the reply, I'll experiment some more and remove the end completely :)

What piece would that be then:o :eh?:

The tip split open.. I got a bit heavy handed when I was cleaning it and pushed the needle a bit hard :yawn:

It's a good job there's a full list of parts included in the box with it then.
You can get the replacment part when you speak to Dave about the stickers.