Faskolor airbrush

[Body Paint]

I've had a loan of a faskolor F1 airbrush.

It turns out to be a really nice brush, it sprays fine or wide just by removing a bezel on the tip and is really easy to purge all the gooey fastkolor paint out of it.

This was what I painted.

[GRIFF55]

If thats mine Craig, you're a bloody star!!!!! , Orange goes with the Jeep Toooo!

[Body Paint]

Flippin eck Andy, that only took you 3 minutes to spot that

I hope you like pink aswell? LOL

[GRIFF55]

Verrrrrrrrry Niiiiiiccccceeeee!!!!! Might go for orange wheels too? Don't fancy cutting the bugger out now tho.
Is that you're car you're on about on the screen?
Thanks a million!!

[Body Paint]

Will look good with white, yellow or orange wheels. I picked up a tip on cutting shells last year, a few northerners were using a dremmel with a sanding wheel. At first I scoffed at the idea but it works great!

Yeh, that is my car on my screen, she sits a lot lower than that now tho

[GRIFF55]

Fiesta looks good, i'll try and find my bm coupe pics that were in redline, Same colour as shell!!! Candy pink . Now an Orange jeep, Whats next?????? perlescent Lime green m3 me thinks.
Thanks again for the shell, i gota go, weekend catching up on me .

[AndyM]

Craig that look fantastic!!

[telboy]

How did the faskolor paint do going through the brush?
No clogging or anything? and does it still look a bit rough when you try to do fine lines?

Faskolor is always clogging my badger.

[Body Paint]

I was able to use the paint a little thicker than normal without any worry about it blocking. I did find that when doing a lot of fine lines that the paint would start to dry on the end of the needle, it would then start to splatter a little, this is rectified but dragging your finger nail over the end of the needle (which is totally exposed when in fine line setup) and then a quick flick of the brush to full blast and you away again.

I especially like the way you can just load the Faskolor bottle straight onto the airbrush.

[DCM]

I can't remember if it is a gravity or suction need airbrush??

[Body Paint]

She's a sucker

[schuwolf]

I'm just using a Faskolor airbrush & Faskolor paints, but having a bit of trouble getting it to fine line. Is it just turning the end bit round or completely removing it? What air pressure are you using?

[ralphee]

Id say remove the tip flare, itll allow a finer set up possibly, and allow access to the needle tip. As for pressure i shoot faskolor at 12 to 15 psi and it works fine through my Iwata and Aztek, hope that maybe helps a little.

lee

[ralphee]

Sorry how rude of me lol, great paint bodypaint, seriously nice job

lee

[Body Paint]

I remove the end piece completely.

I run at 40psi and thin the paint a little with a IPA/H2O mix about a cap full per bottle should suffice.

[tyreman]

Right now get yor arse in gear and do my new shells

[Body Paint]

I have to fix the piece I broke first.. oops

[niggs98]

ipa/h2o ????? i guessed on the water bit and also did you just use the fast colour sealer to seal it all ??

[Body Paint]

isopropanol alcohol = IPA

I use halfords clear laquer, faskoat is a good sealer but a pain to spray as it's so thick.

[schuwolf]

Thanks for the reply, I'll experiment some more and remove the end completely