Gearbox Spacers

[Fozzy1989]

Im looking to replace the plastic spacers used to go through the anti roll bar mount and gearbox on my 210. Not sure what size aluminium spacers i should get as the plastic ones are a ridiculously tight fit. Any ideas?

Thanks
Chris

[mark christopher]

bit smaller than the plastic ones

[Fozzy1989]

lol basically what size should the originals be then, doesnt say in the manual and im not sure if iv been using the right ones as they are pretty screwed once iv got them out

[aeb4]

Originally Posted by Fozzy1989

lol basically what size should the originals be then, doesnt say in the manual and im not sure if iv been using the right ones as they are pretty screwed once iv got them out

If you've followed the instruction booklet then the part number is wrong, but I'm surprised you could even get them to fit. The right ones are shown in the online manual, and they fit nicely, in my car they do anyway

[Fozzy1989]

Originally Posted by aeb4

If you've followed the instruction booklet then the part number is wrong, but I'm surprised you could even get them to fit. The right ones are shown in the online manual, and they fit nicely, in my car they do anyway

That clears it up mate cheers. Found one of the correct spacers on my parts tree, fits a treat. The other unfortunately must have fallen off or binned when tidying after the build