|
||
|
 |
|
||||||||||||||||||
|
#1
08-11-2010
|
|||
|
|||
Intermittent cutting out
Two Sc10s, both with Losi Xcelorin esc, both Savox servos, lipo 5000 mah, Futaba 2.4Ghz, both will occasionally cut out[ no steering or motor] and then come back on when hit by other SC10s! I've removed the battery to esc Deans and have a direct solder of esc leads to gold male bullet connectors into the Lipo.
Any ideas. It never happens whem we run our Mardaves with the same Futaba 2.4Ghz tranny but with Fusion esc etc. Loose connection somewhere, but continuity tests are always Ok. Loose on off switch?? 
|
|
#2
17-12-2010
|
||||
|
||||
|
Losi
It's the Losi excelorin set...they're renowned for it. I have one (no longer in use) and another guy at our club had one, we both experienced the same issue. Not sure whether it's the speedo or the motor or a combination of the two together but when my speedo was attached to a different Losi excelorin motor is seemed fine (apart from the fact that it was either full power or no power).
|
|
#3
17-12-2010
|
||||
|
||||
|
hi fela its your esc drawing too much power which in line reduced the power to the receiver in effect causing the receiver to cut out hence no steering or throttle.you need some power caps for your receivers to stop this happening spektrum make them or you can make your own very cheaply
__________________
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
