|
||
|
 |
|
||||||||||||||||||
|
#1
11-03-2010
|
||||
|
||||
First build diff questions
First time with gear diffs, so...
How much oil to put in, was thinking just covering the gears? Also, what/how much grease on the diff ring gear/pinion, I only have Tamiya greases so it's either ceramic or anti wear or molybdenum grease?? 
|
|
#2
11-03-2010
|
||||
|
||||
|
Just up until the planetry gears are covered will be fine.
 Run through the gears by hand to insure there is not an air pocket and top up accordingly.
__________________
Feedback: http://www.oople.com/forums/showthread.php?t=32506 http://www.dropinnracing.com
|
|
#3
11-03-2010
|
||||
|
||||
|
I fill them just over the cross shafts that hold the small satellite gears in place.
Molybdenum grease would be a good choice Dave, I run a small 1mm thick ring around the main crown gear of the diff, install and then turn the diff around the pinion to coat them both evenly.
__________________
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
