Go Back   oOple.com Forums > Car Talk > Team Associated

Reply
 
Thread Tools Display Modes
  #1  
Old 24-02-2009
colin563 colin563 is offline
Member
 
Join Date: Jan 2009
Location: Skegness
Posts: 225
Smile just got a b44

ive just purchased a b44 used chassis from here

now i need advice

on a brushless combo for it

1 LRP Brushless A.I. and Eraser 10.5T Combo

2Losi 1/10 Xcelorin S 10.5T Brushless Combo

i want it for bashing on my back garden

have i made the right choice in size or do i need less turns for the motor

next what pinion and spur would i need for this

also were would i purchase these from

thanks in advance for any replies

colin
Reply With Quote
  #2  
Old 24-02-2009
rc_penguin's Avatar
rc_penguin rc_penguin is offline
Senior Member
 
Join Date: Apr 2008
Location: Whitstable, Kent
Posts: 428
Default

Go for the losi combo, much better value plus sintered rotor, ive had the earlier automatic set up stuff from LRP and its terrible, i turned it on and the speedo got all confused with itself, then it went up in smoke and melted got a free replacement and it did the same thats personal experiences though not sure about the newer ones. have also had bad experiences with bonded rotors, so go for the losi set up! oh 10.5 turns should be plenty fast enough. Hope this helps
__________________
Will Johnson
Reply With Quote
  #3  
Old 24-02-2009
colin563 colin563 is offline
Member
 
Join Date: Jan 2009
Location: Skegness
Posts: 225
Default

can anybody give any advice on pinion and spur sizes for this setup


thanks colin
Reply With Quote
  #4  
Old 24-02-2009
leightheiceman's Avatar
leightheiceman leightheiceman is offline
New Member
 
Join Date: Dec 2008
Location: Ilkeston
Posts: 29
Default

ive had a losi set 6.5t and it was ok, cheap... much more feel with the latest update, but had few problems and horizon hobbys sorted them.
now i run LRP tc shere (25y warranty) with a losi motor and its much better
.
i run a 19t pinon on standard spur

if you get a losi system dont install set up from the disk! go on there web site and install v2 of the set up program, then you want to update you ESP through the set up, too v2.8 then you shouldnt have any problems.
Reply With Quote
  #5  
Old 24-02-2009
colin563 colin563 is offline
Member
 
Join Date: Jan 2009
Location: Skegness
Posts: 225
Default

thanks for reply and info

weres the best place to buy pinions from also spares

as im going to be breaking a few bits

colin
Reply With Quote
  #6  
Old 24-02-2009
ashleyb4's Avatar
ashleyb4 ashleyb4 is offline
Spends too long on oOple ...
 
Join Date: May 2006
Location: Oswestry
Posts: 6,141
Default

http://www.dms-racing.com/

Proberly the best model shop in the uk.

A
__________________
Ashley Williams

I always thought by 2013 we would have flying cars, but we have got blankets with sleeves!

Reply With Quote
  #7  
Old 24-02-2009
b44_will's Avatar
b44_will b44_will is offline
Member
 
Join Date: Jan 2009
Location: Kilham
Posts: 62
Default

mk racing,very good and very fast.
Reply With Quote
  #8  
Old 25-02-2009
colin563 colin563 is offline
Member
 
Join Date: Jan 2009
Location: Skegness
Posts: 225
Default

thanks very much for te links

as for the pinion am i right think

as long as te pinion is the right dp and teeth and fits motor is fine


thanks colin
Reply With Quote
  #9  
Old 02-03-2009
colin563 colin563 is offline
Member
 
Join Date: Jan 2009
Location: Skegness
Posts: 225
Default

ive just purchased this from the sales section

NOVAK GTB SPEEDO COMBO
with 5.5R motor

is this a good setup for the b44

what pinion and spur would you recomend

i dont want it getting hot or to ballastic

thanks colin
Reply With Quote
  #10  
Old 02-03-2009
Mike Hudson's Avatar
Mike Hudson Mike Hudson is offline
*SuPeRsTaR mEmBeR*
 
Join Date: Feb 2007
Location: oOpleton
Posts: 2,258
Send a message via MSN to Mike Hudson
Default

it's ok, might be abit too ballistic for you if your using lipo, 5.5t motor will get HOT regardless as it's a very fast motor. Standard spur which is (84t) and 17t pinion should be good
__________________
Custom MG-Racing
Associated
DMS
Reply With Quote
  #11  
Old 02-03-2009
colin563 colin563 is offline
Member
 
Join Date: Jan 2009
Location: Skegness
Posts: 225
Default

ive not decided on batteries yet i might just make a couple of packs up

using some of my spare cells

thanks for the replies



colin
Reply With Quote
  #12  
Old 28-04-2009
stampede vxlboy stampede vxlboy is offline
Banned
 
Join Date: Apr 2009
Location: otley / keighley
Posts: 1,747
Default

going get the lipo batterys get the power pumping out and then you will see the differents with nimh battery. i use lipo all the time 7.4v and 11.1v but you carnt race with a 11.1v lipo. battery nimh battery are not there good in brushless sytem .that what i think i used nimh battery before i got lip[o battery but my trucks is traxxas rustler vxl well fast i tryed with 7.2v and 8.4v and 9.6v and 10.8v nimh battery it should be hit about 65mph with this battery but i take 5 mins to get the power to get the speed up my opinion is that i would never buy a nimh battery again waste ov money i got two new battery for xmas 1 that a 10.8v battery and 1 that 9.6v battery so you can say that get 200 charger out ov nimh battery what a load ov shit the 10.8v battery green cell s are shit but my 9,6v battery work ok ish but the 10.8v take about 5 /10 mins for the power to kick out then it work. but that should be speed with this battery 65mph not nimh battery are crap??????
Reply With Quote
  #13  
Old 28-04-2009
Gonky's Avatar
Gonky Gonky is offline
Senior Member
 
Join Date: Jan 2009
Location: Milton Keynes
Posts: 417
Default

yep that did it.... my eyes have just exploded!
Reply With Quote
  #14  
Old 28-04-2009
Mike Hudson's Avatar
Mike Hudson Mike Hudson is offline
*SuPeRsTaR mEmBeR*
 
Join Date: Feb 2007
Location: oOpleton
Posts: 2,258
Send a message via MSN to Mike Hudson
Default

Quote:
Originally Posted by stampede vxlboy View Post
going get the lipo batterys get the power pumping out and then you will see the differents with nimh battery. i use lipo all the time 7.4v and 11.1v but you carnt race with a 11.1v lipo. battery nimh battery are not there good in brushless sytem .that what i think i used nimh battery before i got lip[o battery but my trucks is traxxas rustler vxl well fast i tryed with 7.2v and 8.4v and 9.6v and 10.8v nimh battery it should be hit about 65mph with this battery but i take 5 mins to get the power to get the speed up my opinion is that i would never buy a nimh battery again waste ov money i got two new battery for xmas 1 that a 10.8v battery and 1 that 9.6v battery so you can say that get 200 charger out ov nimh battery what a load ov shit the 10.8v battery green cell s are shit but my 9,6v battery work ok ish but the 10.8v take about 5 /10 mins for the power to kick out then it work. but that should be speed with this battery 65mph not nimh battery are crap??????
...... THATS FREAKING AWSOME!
__________________
Custom MG-Racing
Associated
DMS
Reply With Quote
  #15  
Old 28-04-2009
Richard Lowe Richard Lowe is offline
*SuPeRsTaR mEmBeR*
 
Join Date: Mar 2006
Posts: 2,398
Default

Quote:
Originally Posted by Gonky View Post
yep that did it.... my eyes have just exploded!
lmao
Reply With Quote
  #16  
Old 28-04-2009
Gayo's Avatar
Gayo Gayo is offline
Senior Member
 
Join Date: Feb 2006
Location: Paris, France
Posts: 991
Default

Babelfish translations from japanese are clearer than that
__________________
Schumacher KF | K1 Aero | RWS RZ6R |MiniZ MR-03 | Orion R10 esc | LRP motors | Orion 90c lipos

Rusti Design - Awesome custom stickers and cool stuff

My trader feedback
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT. The time now is 09:37 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
oOple.com