Slipper clutch help

[Peakey]

Hi all
I have started a new thred as not to hijack boons can I have peoples suggestions for a slipper for my Procat I have found a cat 2000 but not sure if it will fit


If not could people suggest another I could modify I have some sx3 bits I can steel

[Moozo]

That will work but you need the lay shaft from a bosscat or cougar2
Part u1214n

Mick

[Peakey]

Just any bosscat layshaft and would a new couger one fit do you think

[lllyf]

the TDS clutch set is mine, it will fit cat2000 series but not the procat

[Peakey]

Not even with modification ? Well that's shot that idea in the foot

[Peakey]

Ok so after a bit of hunting I got a job lot of schumi bits and in it was theses slipper plates



Derbydan said they are from a bosscat slipper? If so that is the way I think I'm gonna go with it so what other bits will I need to get it to fit. And also will it fit to a mms diff setup or am I going to either bite the bullit and use a wasp one or modifie a new slipper to fit?

Help please

[Pacman]

I'm sure that the slipper on my cougar 2 is the same as on my cat 2000. Admittedly the layshafts are different.

[Peakey]

If I have to modify one to fit I can cope with that but I want it to take the strain of a brushless setup