Cougar 2 Works

[Peakey]

I've had some time over the last few days to do a bit more with the cougar and also my counter sink arrived too so I can finish it off.

So out with the old glued up manky diff in with a nice new one and some ceramic balls I found




The towers are a perfect match


This is still in the mock up stage



First and mainly I had to get the rear wishboan mounts fitted and the tub had a lot of material to remove to get the fit I wanted.



So this is how it's sitting now





Thought it would be fitting to polish up some rollers for it too



More to follow soon hopefully and there's still a little something I want to try that I think will finish it off perectly

[Retro RC]

Lol you could have cleaned the plastics up first😱 Looks very nice so far mate can't wait to see it finished.......1 day I might get my s##t together🏎

[Peakey]

Originally Posted by Retro RC

Lol you could have cleaned the plastics up first😱 Looks very nice so far mate can't wait to see it finished.......1 day I might get my s##t together🏎

I did say MOCK UP stage 🙄 I needed to make sure it fitted before I clean it all and decide what arms to use they were the first ones I grabbed.

[xfactor]

Looks cracking J.

I know you said mock up matey but just check your belt adjusters. Need turning a good 180. Dont forget.

Love the carbon matey against the purple. Made the rite choice there matey.

[Peakey]

It's getting closer to completion just a couple more bits to do like decide where to put the battery 😁

[daz75]

Looking good what colour shell are you going for pink?

[Peakey]

Not sure yet I'll mask it up and see what I come up with, I don't think I've got any pink paint though

[Peakey]

Gear cover fits well

[zzzubbb]

Love the yokomo wheels !!!
Very cool

[Jon.d]

Looks ace I'm hoping to get my hands on 1 in next couplve week but will need a gear box from wot I can gather love the chassis ��

[CATS]

Just sent u a pm

[Peakey]

Originally Posted by CATS

Just sent u a pm

Like a vulcher 😂

[mporter2000]

How does the works gear cover stay on?

[autoxvw]

Originally Posted by mporter2000

How does the works gear cover stay on?

Friction.

[Peakey]

Originally Posted by mporter2000

How does the works gear cover stay on?

There's 3 small screws that hold it to the motor plate

[Retro RC]

Very nice Peakey I see your going for your updated slipper setup to.
Did you find you had to dremmel a small amount out of the back of your fibrelyte towers to get them to fit over the front bulkhead?