Show me your Durango's

[motocross13]

This is my ride for this season

[GRIFF55]

Just for you Nitrokillah. Paint by www.mikovic.com
My pics don't show the quality of the carbon effect but maybe sco77morgan can post some better ones?

[nitrokillah]

Lookin' SIC andy .

Seen these ones . on the Mikovic Site .

[Adam Skelding]

Originally Posted by GRIFF55

Just for you Nitrokillah. Paint by www.mikovic.com
My pics don't show the quality of the carbon effect but maybe sco77morgan can post some better ones?

I liked your plain yellow sooo much better!

[GRIFF55]

They just took up too much time getting the design right!!

[telboy]

I know what you mean!!!

[CharlieF]

Hot Griff very HOT.

[kriske]

Originally Posted by GRIFF55

Just for you Nitrokillah. Paint by www.mikovic.com
My pics don't show the quality of the carbon effect but maybe sco77morgan can post some better ones?

[rcardoso]

Some pictures of mine not finished yet...

[mikeyscott]

Is that a B4 set-up station?

[rcardoso]

It´s an M-Racing setup system I bought for mine b44.
It´s universal for 1/10 buggies I think.

[DaSloth]

have you tried mounting the shell with that electrics install yet? I have that receiver and when i mounted the shall, it was pushing out to the side when it was mounted similarly to yours. I ended up standing up the receiver and moving it in a bit so it didnt overlap the side "pod."

[rcardoso]

Yes it push a little. Its just 1mm that the receiver has to move to the middle of the car, you can cut the antena suport a little and move the receiver to the inside.

[TNT]

New 11th in our track!

[littlened]

the durango is simply the nicest looking rc I've seen.

[GSXR1000]

Here's mine :
Roll-out left me with a big grin

[nitrokillah]

Originally Posted by GSXR1000

Here's mine :
Roll-out left me with a big grin

What did you add on you ballcups ???? & why ???

[GSXR1000]

Read somewhere that the tie rods had a tendency to get pushed into the ballcups in the event of a crash - so I made some ally tubes that have a thight push-fit on the ball cups; reasoning being that the soft plastic of the ball cups might not open up and the threads in the plastic might hold - no idea if it'll work

[HyperFX]

Originally Posted by GSXR1000

Read somewhere that the tie rods had a tendency to get pushed into the ballcups in the event of a crash - so I made some ally tubes that have a thight push-fit on the ball cups; reasoning being that the soft plastic of the ball cups might not open up and the threads in the plastic might hold - no idea if it'll work

Seems reasonably sound. Similar to the ali sleeve on a plastic, light weight outdrive.
Looks good. Is it a standard size tube, or did you need to modify the inside diameter?

[GSXR1000]

I began with 5.9 inner diameter sleeves but on some of the ball cups they were too thight - ended up with 6mm - I guess most commercially available stuff is 6.1 inner diameter because they are meant to fit over an 6mm axle