|
#1
|
|||
|
|||
![]()
Hi all
What's the general consensus here? I'm half decent at soldering. 1 Open ESC/servo and shorten/solder at board 2 Cut wires mid way/shorten/solder/heat-shrink 3 Cut connector off/shorten/crimp new connector on If it's crimp new connector, any recommendations on a starter set for crimping with tool/connectors included? Loads on the 'bay but never sure on quality. Any thoughts appreciated, thank you |
#2
|
||||
|
||||
![]()
Send to NextLevelRC and have black ones put on.
PM 'Ben' on here ![]() ![]() ![]() ![]()
__________________
|
#3
|
||||
|
||||
![]()
Funnily enough, I did one earlier today. Option 1 for me - because I wanted to use black wires. I do also use option 3 if it already has black wires! I have crimp tool that I bought years ago from a shop that did a lot of flight stuff.
__________________
Matthew White |
#4
|
|||
|
|||
![]()
Any further thoughts on this? Still haven't got round to doing it but still considering it!
Any advice on cutting off/crimping on new connectors? Decent tool for the job? |
#5
|
||||
|
||||
![]() Quote:
![]() |
#6
|
|||
|
|||
![]()
I bought a proper crimping tool, watched a video which made it look easy.........not sworn so much for a long time! Getting the littler 'kers back into the plug was just ridiculous and then a wire pulled out..
Unless you have a lot of patience or a hatred of heatshrink, I would just shorten/solder/heatshrink your existing one |
#7
|
|||
|
|||
![]()
Can anyone please point me to him?
Thanks |
#8
|
||||
|
||||
![]()
"Ben" is Ben Jemison team Schumacher driver and all round nice guy
just look in "community" section and send him a PM im sure s a member of York club he based up that way I too have a crimping tool success and failure in equal measures at times im not sure I can afford to keep buying plug/pin repair kits to practice on !! I just tend to "loosely" coil excess wire and cable tie having 50 or so chariots to play with ,electrics do tend to get evicted and rehomed occasionally regards dave |
#9
|
|||
|
|||
![]()
There's so many Ben's on here. How do I know which one he is? Lol!
|
#10
|
||||
|
||||
![]()
His username is Ben I'm pretty sure. Also he runs NextLevelRc. Look on facebook for him.
__________________
|
#11
|
||||
|
||||
![]() Quote:
Servo plugs http://www.hobbyking.com/hobbyking/s...dproduct=65799 Crimping tool http://www.hobbyking.com/hobbyking/s...arehouse_.html These are good quality and all I use these days instead of soldering. It does take a little bit of practice but is simple once you get the hang of it.
__________________
Visit my showroom |
![]() |
Thread Tools | |
Display Modes | |
|
|