Servo Arm 210

[OneKiwi]

Is there a alu arm that fits without modding?

Is the losi one a good fit? Or could someone tell me how long it is thanks.

I don't mind the TD ones its just there is a lot of extra stuff on that parts tree that I don't want or need.

[mattr]

Get the TD aluminium one, fits in the 410 perfectly, should be a good fit in the 210(?)

[paulc]

Losi one fits fine use the bottom hole of the two and put a 2mm spacer on so the steering link is straight

[mattr]

Oh, forgot to mention, i'll be fitting the Losi (TLR1557) one to mine once the rest of the hardware turns up.

[OneKiwi]

Ill have to check it out or see if I could borrow yours Matt and test.

I did find one on the nitro car that fits, hope the servo gears hold up

I did find a couple that may fit but they don't have measurements

ONE
TWO this one has 20mm hole to hole (need about 15/16mm I think) , thats a little long but might fit in the other hole and trim the end

[mattr]

I'll have it with me on wed. But the rest won't show until Friday (if i'm lucky!) So you can fit and use for a few days. (and get a measure of the td one)

[hottuna]

I'm using the Losi 99032 in my 210. Length and angle is perfect. But you need to re tap it to mm thread if you use mm ball stud, but that's no problem as 4/40 is 2,78mm, the threads will be fine

[mattr]

Just eyeballed the stock one and the tlr, perfect match on length and offset.

[slowjun]

This one i used on my 210.



need to tap the screw to fit the 4-40 into it.

http://www.amainhobbies.com/product_...vox-ACE-TLR-22