Electric Install Pics

[Big G]

Originally Posted by macmaxx

big g, are running w/o capacitor??

here's is mine

the cap' is in there. you can just see the silver part by the sensor plug

I ran a 25t pinion on the 7.5 at Kiddy on Sunday in that heat and no problem with the car. shame the servo chewed a gear and the wheel fell off lol

[The Chef]

Got there in the end.

[Chris-S]

Done a bit of rewiring, cut the switch off and shortened the capacitor wires, servo/esc/pt wires will get shortened at some point

[bryan durango]

my v3. just rewired and new motor fitted.

[raymondkerr]

Nice neat job Bryan, but you need an aerial tube for that receiver aerial.

[bryan durango]

thanks raymond. i was thinking about an aerial tube but it would only stick up about an inch. might just leave the wire under the shell. when i get my shell on sunday from mg paint

[gixxer1000rider]

i love this thread!

i am in the process of building a 410R and installing the electrics. i am running a speed passion 2.0 GT and stock 13.5t V3 motor. i am yet to buy my RX/TX and many people have mentioned a micro receiver for ease of install, are these normal? which RX come with micro receivers?



Thanks

[Andrew Twigger]

Here's my effort. Snug.

[pato.b]

My install

[mattr]

Originally Posted by gixxer1000rider

i love this thread!

i am in the process of building a 410R and installing the electrics. i am running a speed passion 2.0 GT and stock 13.5t V3 motor. i am yet to buy my RX/TX and many people have mentioned a micro receiver for ease of install, are these normal? which RX come with micro receivers?



Thanks

Don't think many actually come paired with the micro receivers, but i use spektrum, which has a micro receiver available. Might be worth seeing if the new 2 channel spektrum is compatible with the micro Rx (i suspect it is). As that looks very good for the money!

[/tobys]

KO Universe 3 comes with a micro RX

[lambert]

410 1.jpg

410 2.jpg

tight squeeze! Not much room at all

[samd]

Originally Posted by pato.b

My install

Looks nice, any chance of a close up shot?

[reg]

samd

[pato.b]

[caneye]

Originally Posted by lambert

Attachment 35485

Attachment 35486

tight squeeze! Not much room at all

you could cut crimp the servo wires. will free up a bit of space

[matthew]

Originally Posted by caneye

you could cut crimp the servo wires. will free up a bit of space

Just out of curiosity what do people use to crimp servo wires to the servo conectors?

[caneye]

you can find them on ebay but otherwise this place below is pretty reputable:

http://www.hansenhobbies.com/products/connectors/tools/

i've got the Economy crimping tool and it meets all my requirements.

[jespero]

My new setup. Epic Trinity revtech 6.5, Speedpassion Esc and Sanwa RX.

[Snowey]

Here is my first ever install, this thread was very helpful!!