Servo horns for Savox SC-1251MG servos

[dev]

I seem to have spent ages trying to sort out a servo horn to fit my new Savox 1251 low-profile servo.

When you fit a standard Team Associated 25t horn (the type you get in a B4 kit) to it the ballstud / ballcap fouls the servo case near full lock and the linkage is at the wrong angle (too close to servo, linkage is out of line). This seems to be because the output of the servo doesn't project as far as other manufacturers.

I have tried a losi TLR1554, but even though they look like they are offset horns, they seem to have exactly the same offset as an associated one.

Any suggestions for other plastic servo horns that have more offset? I was sure losi made some longer ones for one of their 1/10th trucks years ago, but I can't find them now.

[Bigbaddave]

I think the fitting is tight on these servos but run one in my Xray T311 / B44.1 with original horns and no issues. Have you tried an Xray one from a T2/T3?

[MikePimlott]

Mines got a Losi xxxcr 25t horn on it. Fits perfect has quite a large offset and the ball is facing the servo.

LOSA1620

[dev]

Thanks for the ideas, I'll get some bits on order and see what I can make work!