crunch spacers on the driveshafts?

[captainlip]

the manual says put them on the outside of the hubs on the wheel side, which i have been doing, but what - or + effect will i get putting them on the inside thus shortening the wheelbase?

[captainlip]

sorry i mean the distance bushing. any help while i have the shafts out.

[ian h]

I would imagine that by moving them inside the hub you would move the drive shaft too far into the diff outdrive. Not good I would imagine.

[captainlip]

good thinking! put them back as they should anyway.

[Hulk]

Hi mate,

by putting the gold washer on the inside of the hub your reducing the cars track width.

A narrower rear track width will:

• increase grip at corner exit
• increase high speed understeer
• be more prone to grip roll

A wider rear track width will

• increase rear grip at corner entry
• increase high speed on throttle steering
• use to avoid traction rolling

Hope this helps

Craig

[captainlip]

cheers boss! will leave it as the latter