vintage belts from SDP

[kaszal]

I bought some replacement rear belts for my Procat from www.sdp-si.com

part No. A 6B16M071060

These are the same pitch (MXL) and nearly the same number of teeth (71 instead of 72) but a little wider (6mm instead of 5mm) and made in urethane with kevlar reinforcement. The tooth profile also looks a little different (new ones are grey). They only cost $3.34 for a pair.

Do you think these will be better, like the BRP orange front belt is better than the kit rubber belt?

[isobarik]

Looks awsome try www.beltcorp.com they can provide belts and they can also cut them if you want to get the right width.

mvh isobarik

[kaszal]

Unfortunately the 71 tooth belts are too tight when used with the pro-diff and narrow eccentrics. Back to the drawing board!

[isobarik]

Originally Posted by kaszal

Unfortunately the 71 tooth belts are too tight when used with the pro-diff and narrow eccentrics. Back to the drawing board!

Check this one out then ...http://beltcorp.thomasnet.com/item/g...eoprene/72mxl?

could work....

mvh Isobarik

[kaszal]

Thanks! Those are neoprene... aren't the urethane belts better?

[slowjun]

will those belts also work for a YZ10 Fine pitch Front and rear Belts.

Sample pics.




wanted to have some spares so that i could run my runner. any links help will be appreciated.

Thanks Guys.

[kaszal]

The MXL belts all seem to have a trapezoidal tooth profile (grey belt in the photo) but does anyone know what pitch are the "hi-torque" belts (black belt) with the rounder tooth profile?

[isobarik]

Originally Posted by slowjun

will those belts also work for a YZ10 Fine pitch Front and rear Belts.

Sample pics.




wanted to have some spares so that i could run my runner. any links help will be appreciated.

Thanks Guys.

yokomo fine pitch belts are M2 pitch