Heavy Duty Adjuster TRF511

[simoncrabb]

Kyoshos Hard Ball End Set 97021H

There's 12 big uns and 4 tiny uns in the pack.

[Welshy40]

UM112 but you will need to buy two lots for your car as there is only six long ones in each pack.

[simoncrabb]

UM112 aren't the big long ones?

[MHeadling]

Once I know what part no to order I think I am going the Kyosho route as the HB ball studs are a bit of a pain to get at the moment.

[simoncrabb]

Kyoshos Hard Ball End Set 97021H

Google that part number and you'll see they should be what you want.

[AaronR]

You can also use two of the very short Kyosho ball cups (that come with the set that Simon linked above) for the servo turnbuckle/linkage. They are the same length as the short Tamiya cups.

[MHeadling]

Good stuff! I have just ordered a set up and see how they go!

[Welshy40]

Originally Posted by simoncrabb

Kyoshos Hard Ball End Set 97021H

Google that part number and you'll see they should be what you want.

I didnt know about this one, thanks for that.

Something I can order as well instead of the normal ones, and looks better than UM112. Cheers.

[fastinfastout]

bump

are the new ball cups available to the public, which only the team drivers had access to?

want my 201x built right from the start, when I get it

[AaronR]

I'll say it again...

Originally Posted by AaronR

HPI studs (75115 & 75116) with Losi grey rigid cups (LOSA6016) are a great solution!

[fastinfastout]

I want tamiya ball cups on my 201x, as I already have tc5 ball studs/losi white ball cups on my current car.

Just changing to good ball cups is the easiest to achieve.

Does anyone have the part number for the trf ball cups?

[Fredrik Emilsson]

201 comes with new grey ballcups. No need to change them.

[BloodClod]

Originally Posted by Fredrik Emilsson

201 comes with new grey ballcups. No need to change them.

The part number in the TRF201 manual for the ball cups is the same as the ones previously used in the 511. I don't think these are newer ones unless tamiya made a running change without updating the part numbers?

[fastinfastout]

yes and also the ball cups used on the 201x are the same as the db01, which everyone is swapping out for stronger ones.

maybe they will never be released

[Fredrik Emilsson]

Trust me, 201 comes with new grey ball cups. Take a look in the 2wd thread.
Tamiya made a running change without updating the part numbers.
Here´s a pic:

[carnage]

any ideawhere to get the "new" adjusters from, not the old ones considering they have the same part no.

[TRF_AK]

Coming soon.....

[carnage]

Originally Posted by TRF_AK

Coming soon.....

how soon

[mattybucks]

I need some of these for Sunday's regional at DMS, as the kyosho ones I have on my 511 need replacing, are they in the country yet?

I know the hobby company still have the old ones, as I called them yesterday. Has anyone been using the old ones? What are they like?

If anyone has any spare then please pm me paypal waiting.

[DaveG28]

I'm sure I'll be the only one to say this but....I prefer the old ones!! Have not popped a turnbuckle in over 6 mtgs with them! I have a feeling they just had a bad batch tbh..