mad rat shock oil

[el nino]

the kit instructions say to put shock oil in,but not how much,there is a bottle of oil with the kit.is it just for lubrication or a specified amount for damping?

[Battle_axe]

Originally Posted by el nino

the kit instructions say to put shock oil in,but not how much,there is a bottle of oil with the kit.is it just for lubrication or a specified amount for damping?

you need to fill each shock to the top and then pull slowly up and down on the shaft to get all the air out leave it to stand for a few mins so all the air comes to the top then push the shaft halfway up and screw on the top i hope that helps

[wolf]

1. Assemble shock cap, with diaphragm
2. Fill shock to top
3. Pump piston to bring trapped air to the top
4. Top up oil, to top
5. Fit shock cap, wind in, then back off, one turn
6. Push piston in, to get right amount of rebound without over-pressurisation of the shock
7. Tighten shock cap, clean oil

[el nino]

thanks, is this going to be a really messy job, or can it be done carefully without much spillage?

[92nc30]

As long as you pump the piston up slowly you'll be fine.
First time I did it I pushed it up far to quick and got the ceiling and my eye covered in oil.

[kaylon]

For Shock work something like THIS is a must have... Not only a great car station but has shock holders on one side for when filling with oil

J