few problems

[rcardoso]

Finally i got my durango and started assembling it...
I must say the car is amazing but i had some problems/questions:

- When I started building the shocks i noticed the piston on suspension its not a tight fit, but no problem here i tought... When finished assembly i checked the sloop holding the shaft and it plays too much.. Is it normal ??

- How do you tighten the rear sway bar on the rear arm ?? I cant hold the part where the screw goes.

Thank you

[Dave C]

remember if you haven's slop, it's hard to move the shock shaft smootly, so a little play on the pistons is fine...

for the sway bar mount in the lower arm, i know myself it isn't the best solution, but a little tread lock (like manual says) on the screw would hold the ball fine

[rcardoso]

Thank you for the answer.
I will try that.