|
|||||||||||||||
|
#1
|
||||
|
||||
|
On Xray T2'009:
I'm using my club control wheel/tyre setup of schumacher 20mm wheels/ 20mm mini pin tyres. Do they need to be glued if using on indoor school hall type hard polished surface with 13.5 brushless? |
|
#2
|
||||
|
||||
|
you sure do. To see what happens if you don't, mark the relative position of the wheels and tyres, then run a heat. See how the tyre moves on the rim. You may also get a tyre partially off a rim. When you do glue, you'll only need a couple of spots.
|
|
#3
|
||||
|
||||
|
I ran those tyres a lot in the past and never glued them, never had one come off. This was using the blue inserts, I have seen the odd tyre come off using the soft white inserts.
|
|
#4
|
||||
|
||||
|
TY, for help: They seem perfect unglued
__________________
Xray T2'009/B44/B4 |
|
#5
|
||||
|
||||
|
they might be ok unglued , but if you hear your car making what i like to think sounds like a lightsaber from star wars noise when you go round corners then that is the tyre spinning round on the rim and they will probably need glueing
|
|
#6
|
||||
|
||||
|
Glue then you know they wont fall off in the race
|
|
#7
|
||||
|
||||
|
Ok, you guys have convinced me, I'm being lazy. I'll glue them :0
__________________
Xray T2'009/B44/B4 |
|
#8
|
||||
|
||||
|
|
#9
|
|||
|
|||
|
there's no need to glue them with a 13.5 motor. If you're putting in a quicker motor, then maybe, but definitely not with a 13.5
Last edited by chris_dono; 17-08-2009 at 06:15 PM. Reason: typo |
|
#10
|
||||
|
||||
|
Lucas, if you remember I was running unglued a few weeks ago and lost the A Final due to the rear coming off (inwards) causing the car to drive like a crab in the last few laps. I've since glued them now and no problem since, and that's running 13.5 in my 008 Xray.
I guess it depends how hard you are on the car. My minipins have only lasted 4-5 meetings, yet Cory's set still look good as new. You might get away with it as the 009 is new to you, but I would suggest you glue them before the championship starts in 4 weeks. Regards Scott www.bedsrcmcc.co.uk |
![]() |
| Thread Tools | |
| Display Modes | |
|
|