Neat and tidy

[Cassp0nk]

I've gone with corallys because trakpower cells use them, but honestly, what is so good about them? They are just ripe for shorting on things.

[JackWood]

Originally Posted by Cassp0nk

I've gone with corallys because trakpower cells use them, but honestly, what is so good about them? They are just ripe for shorting on things.

Put some heatshrink over the solder joint on the Corally.

[telboy]

It looks as though most people are using velcro to fasten the Lipo's in now.
Is that the way to? I think so.

[Oliv996]

Very soon, I will run for the first time my CAT SX "LiPo inside" and Tekin RS Pro :hurt3:

Here are 2 pictures of the configuration, please note all components lay down onto the chassis.

The Tekin RS Pro, is used with version 189 of the software in "sensored" mode. Coupled with Velocity 6.5R plus 13mm rotor, the car seems to be ace

[Lee]

I always love your cars Olivier, even if you have taken a step backwards by going to schumacher

Tres bien

[showtime]

Originally Posted by Cassp0nk

I've gone with corallys because trakpower cells use them, but honestly, what is so good about them? They are just ripe for shorting on things.

bit like any 6 cell Nimh pack with exposed battery bars down both sides then

unless you're a total Jonah shorting shouldn't be an issue!

[Oliv996]

Originally Posted by Lee

I always love your cars Olivier, even if you have taken a step backwards by going to schumacher

Tres bien

Thanks Lee

I was addicted to my X-5 few years ago, and I tried to do y best to improved what could be improved on it.... but due to poor reliability of some main parts, I decided to turn the page. End of the love story
But every time I think about X-5, it reminds me that it may be the best car I ever drove for a 5min run...

[Lee]

5 minutes is all you need, anything more and its just showing off

[sly]

Originally Posted by Oliv996

Very soon, I will run for the first time my CAT SX "LiPo inside" and Tekin RS Pro :hurt3:

Here are 2 pictures of the configuration, please note all components lay down onto the chassis.

The Tekin RS Pro, is used with version 189 of the software in "sensored" mode. Coupled with Velocity 6.5R plus 13mm rotor, the car seems to be ace

In the first picture is a slipper arrangment on the one-way pulley, i have looked at schu website and can not see a part no. etc.
What part number is it?

[MotoRev]

Originally Posted by Bungleaio

Wiring looks really good mate, I always aim to have it as tidy as I can but it always looks a right mess.



I'm sure I only paid £65 for mine too! How can they justify charging £95? I wouldn't be without mine though and I've just sent mine to MRT to be cloned so I don't have to keep moving it between cars.

Euro v's Pound. In a nutshell boys..

[Oliv996]

Originally Posted by sly

In the first picture is a slipper arrangment on the one-way pulley, i have looked at schu website and can not see a part no. etc.
What part number is it?

Hi Sly,

It's a home made ABS (as it was called in 90's for CAT2K). Please have a look on this thread