Advice on drilling

[chrispattinson]

I have some Yokomo rear hubs which I will be fitting to my Tamiya for the weekend. The hingepin holes need to be enlarged. Is it ok to run a drill through them, or do I risk altering the the toe in? Any advice appreciated. Thanks.

[Chequered Flag Racing]

you'd probably be better of using a reamer but not the type used for making holes in wings

[chrispattinson]

Where do I get one of those?

[DCM]

tapered reamer is your best bet, and any decent tool shop.

[chrispattinson]

forgive my ignorance, but is B&Q a decent tool shop. I might go down and ask to see if they have anything here at the factory to do this aswell.

If I dont manage to get one, will I end up making a mess of it with a drill?

[Southwell]

I would search the yellow pages for a small tool shop, they generally have much more experienced people working there.

[mark christopher]

hudy etc do hinge pin reamers

[chrispattinson]

Thanks for all of your advice, it seems we have the gear here in the factory to do it.