|
||
|
 |
|
||||||||||||||||||
|
#21
02-04-2017
|
|||
|
|||
I got started on the steering system , there are a few areas that need attention as yet , i have a slight binding issue on the track rod ends with suspension compressed but i have a couple of ideas to overcome it , clearance is tight as the links go under the diff out drive cups and there's only 3mm so they are just over 2.5mm thick , bump steer is acceptable and probably less than stock , its not clear in the pictures I'm afraid , the top part of the top crank for the linkage is over size at the moment as i was not sure of the relative alignment of the top and bottom arms as its not 90 degrees so i thought I'd fit it and then mark the position for cutting later .
the really good news is that it all fits under the body.      
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode