Revention 1.1 out of the box issue

[martgifford]

Hi

I recently bought a SP revention, soldered and with a new M12 put it in a car. The M12 is binded correctly as I have tested it with another working speed controller.

I am struggling just calibrating and setting it up

When I plug in the esc to the battery, and press the on button the orange light is on and solid. I have tried various different things to get it in calibration mode such as holding the button when switching it on, holding it for various periods of time. I just need to get it calibrated and I need a red light for that.

According to the manual a solid orange light means its sensorless but i have a sensor wire connected and have swapped with mutiple wires and motors to eliminate this as a fault.

There is power to the fan, but interestingly there is no power to the esc as I think an Sanwa RX-471 should light up with a blue LD.

Any suggestion to where I am going wrong?

Much appreciated

Martin