another newbi question about wishbone wobble.

[shep]

Hello everyone, I have a dex410 v3 and have noticed that my wishbones have a very small amount on wobble where the hinge pins goes through. It is only a small amount but you can notice it when holding the wishbone near the diff and pushing it back and forth.

Is that normal? I have all the spacers installed correctly and everything is tight.

Also there is a small amount on play in the caster blocks, they can also be wobbled back and forth when i hold the wishbone near the hub end and plus them back and forth. again the correct spacers are installed and everything is tight.

I guess this is completely normal but though i would check just to put my mind as ease.
Thanks
Harry