Toe and anti squat on the cougar kf

[Jsmith]

Looking at the setup sheets on petit rc. It says 3mm difference for the toe giving 3.9dg of toe in. Then below says rear 3mm front 0mm this gives the 3mm difference but where does this 3mm go? is it 3mm in washers between the moulded block and the lower bulkhead??

And where do the antisquat washers go? It says 2mm difference giving 2.6dg of antisquat. Yet under it it says 0mm rear and 3mm front. Surely ghis is 3mm difference.

Im still using the moulded blocks as the alloy ones are out of stock non stop.