Issues with a Nosram Comet Evo

[ChrissieL]

Hi,

I've been running this esc for a while now and a couple of meetings ago, my car stopped dead after 4 mins. At this point I changed the motor and sensor and it was fine until 5 secs before the end of my second final when it happened again.

I then raced a full meeting fine.

Then, last night, it stopped twice around 4 mins again. I managed to spot the lights flashing - red and blue. These very quickly reset and went back to operating. These lights indicate a rotor issue. However the fact I used two different motors discounts this. Not only have I changed the motor, but sensor wire and lipo packs. I've also tried with and without the lipo/ thermal cutoff enabled and disabled with the same results.

In all cases, I've still had steering and the lose of power is not gradual, its instant. Nor is it just under acceleration.

Any thoughts?

Regards

Chris