problem setting up Naza M Lite with Turnigy 9x Radio - RX-ERROR

[raymondkerr]

Just got my naza M lite and installed all the hardware this afternoon. When I load up the naza assistant software I'm getting a RX-ERROR flashing red. Checked all the servo plugs at both the receiver and FC end. made sure in the calibration screen that I was on PPM, I was getting some stick movement feedback from the software but then it stopped. I installed the latest software from dji.com and done a firmware update, although it is still telling my that the firmware and software are v1.0. the firmware upgrade seemed to work ok, all points were green.

Just cant seem to get the RX talking to the radio via the software. The USB driver is working on windows 7 as it should, the LED shows solid green when I plug the USB in, and I get the usual USB dong sound when connected.

Its just a standard box stock turnigy 9x with 9x8c receiver, I have tried it on both traditional and PPM without success.

Wonder if any multirotor gurus on here might be able to advise me.

Thanks
Raymond