Go Back   oOple.com Forums > General > Vintage RC

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #1  
Old 01-07-2013
rob m's Avatar
rob m rob m is offline
Senior Member
 
Join Date: Jun 2009
Location: rochdale
Posts: 463
Default lazer zx gearbox help

hi all, i have just finished stripping cleaning and re building my lazer, i think its a zxr but not 100% with that, the part i need help with is the assembly of the main shaft. ive assembled it from memory.

starting from the spur gear side, i have......

lock nut
limiter coller
4 wave washers
guide plate
slipper plate
spur gear with balls
slipper plate
rear drive hub
drive pulley
pulley flange
8mm o/d x 4mm i/d 1.5 thick washer
thrust bearing
8mm o/d x4mm i/d 1.5 thick washer
E ring
drive pulley
pulley flange
shim
front drive hub
limiter collar
lock nut

hope all this makes sense. the part im not sure about is were i have put the thrust bearing between the two washers. i have downloaded a manual and no thrust bearing mentioned, just a collar. but i don't have a collar that fits. so if anybody can point me in the right directionwould be much appreciated.
thanks, rob.
Reply With Quote
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT. The time now is 02:36 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
oOple.com