SV2 setup sheet clarification question

[Chris Elworthy]

Hi Lads,

I've been looking at setup sheets on the Petit RC site for the sv2 and am a little confused regarding the rear camber link.
On the sheets regarding the rear link washers I understand that one measurement is for how many mm of shims go under the ballstud but what is the other measurement for? The diagram appears to point to the plastic 2mm spacer that goes between the bulkhead and the camber link plate so does that mean if the setup sheet says 1mm for here is that an additional 1mm spacer above the plastic spacer to raise the camber link further or does it mean the plastic spacer is removed all together and a 1mm spacer is used in its place?

Sorry if this comes across a bit confusing its a little hard to explain without the sheet in front of me.

Can anybody help me out?

Chris