Savox 1258 - Won't centre

[jo90]

I have the above servo and a niggling issue. Im guessing this was caused in a big off as the DEX210 doesnt have room for a servo saver, so im guessing the cause is this.

Fault symptoms are that the pot that controls the servo coming to centre isn't functioning right. It is currently about 20 degree's to the right to stop the servo motor (if placed in dead centre the servo motor just runs)

Effectively this meens with my trim set to L-0, R-0 the car is driving to the right in large circles. Im having to wack on about R-30 trim to get the car straight. This is also effecting the steering end point as it is only just getting full left lock now (the servo is at full turn at this point).

Im guessing the pot is now bust but i wondered if there is any way to replace this at all ? I did take the servo apart but i can't get the pot/motor assembly out, it seems glued in (both motor screws where fully removed)

Any help is gratefull appreciated

cheers

john