still issues with new SP ESC

[glx]

Hi Mick, sorry not sure of your name on the forum.

Was delighted going home yesterday with my new SP stock club ESC as it looked like plug n play type - great for me ;-)

So I set to the task and desolder the 3 wires to the motor from the GTB and solder the new wires from the SP ESC, connected to the Rx and plugged in the battery - managed to do the calibration with the Tx and switched off the Rx all as instructed by the manual then turned it on and nothing :-(

the orange and red LED should be on solid but the red one is flashing indicating from the manual the ESC detected low battery voltage ??? strange cos the battery used was charged. so swapped battery and same.

gosh - if I had any hair left I'd be pulling them by now !!!

Any idea why ? is it because I'm not using the corresponding SP motor from the combo ? (the motor I use is a Tekin 10.5T - I know it works as I used it before with no problem) might get it to be on the safe side !

I double check that I solder the 3 wires properly A-A, b-b, c-c, the sensor wire is connected. can't figure it out !!!

Cheers,
G.