DESC410 V2 issues

[slowjun]

So i raised this issue to Team Durango support and yet to get any reply yet, my first email was replied but after sending in the Kit ID and some photos, never heard from them again... so might as well share this issue on here..

1. Missing ball cup tree.

2. Mod 1 spur hitting the plastic support







3. Mod 1 spur excessive burrs. have to remove the burs just to install the friction plate.







DOnt know if the Mod1 spur has issues thats why it was hitting the plastic support, it will spin freely if you remove portion of the plastic part, which i did not do till i was advise by support that it was intended by design, i do hope i installed it incorrectly and can be rectified ASAP but if not then i think TD should act on this one....

so any TD guys on here share to assist.

Thanks,.