Camber Change/Roll Centre Question

[markwilliamson2001]

Hi all,

I am after some advice regarding setup.
I have a 1.16th 2wd micro scale home-made car, which is going pretty well (See the Kitten SV thread n the schumacher section).

I have a small setup issue which I am trying to resolve, involving high speed cornering, where the car seems to 'bobble' and twitch a bit off power when turning mid-corner at high speed.

It does it a little bit at low speed, but is easily controllable here.

I think and it feels a little like the rear roll centre needs adjusting, but I am unsure what to do.
I think it needs the inner ball-stud raising to resolve this, would this be right?

Thanks for any help/advice.

Regards
Mark