TRF201: Servo compatibility?

[Origineelreclamebord]

I recently bought a NIB TRF201 at good price. I thought I should buy a good servo for it (I've only been using standard servos like the Futaba S3003 so far, so I'm not looking at the most expensive servos, but at least bearings, a litle more speed and/or power would be nice). So off I went to look in the manual to look up the measurements that my servo needs to have.

I searched, and searched, and searched... but found there was little information about servo sizes - and the ones I did find the measurements from (mostly Savox servos, they list it on their website) don't seem to fit, because the length between the mountings is too big and/or because the wheel of the servo extends 0.8mm too far from the mounts.

I did see however that some people were using servos that according to Tamiya's specs should not fit. This made me wonder... What servos are you using in your TRF201, and what are the following measurements on your servo:

- Horizontal distance between the mounts (should be 48mm according to the manual).
- Distance between bottom of the mounts and top of the servo wheel (should be 12-16mm according to the manual).
- Distance between bottom of the servo and the bottom of the mounts (should be less than 30mm).

Thanks in advance for your help