TRF502X Setups

[DaveG28]

Just thought a thread might be useful for questions/answers, I know Lee has been saving setups on trfracing.co.uk, this thread may be useful for discussing those!?

In terms of my own setup, I'm running the old Hupo 511 setup on my 502 with the following changes:

0.5 degree rear hubs
One coil cut off rear springs (I use yellow)
JT models steering arm, in forward position
Flipped inner camber links so ball stud sits below the links just above the outdrives (at a guess about 3-5mm lower than kit!?)
Run outer hole on all inner links to enable the above


Questions I have for other people using the car are:

1. Has anyone tried 1 degree rear hubs, if so how did they work?
2. Anyone usig the short wheelbase from Lee's setups, again how have they worked
3. Anyone using Blue rear springs? Again, effect?
4. How is everyone running their camberlink setup?

Combinations of the above!?

Also, how sensitive to setup change are people finding the car? I find it less ensitivs to setups than the 511, not sure that's a good thing though!!