X2c indoor set up with mods

[millzy]

hey guys,

few of you have asked for an indoor set up for the x2c, try this and let me know how you get on, any questions please ask

front
Oil 35w
Spring AE Blue
Piston 3 hole taper drilled to 1.2 all round
Shock set to 78.5 over all length
2mm external limiter
Middle shock pick up on tower
Outer shock pick up on Bone

Camber link, Outside on Tower Inside on Hub, 2 washers under ball stud ( on tower)
25 front hubs ** trimmed 2mm and set backward on wishbone.
Axel set to low ** trimmed 1mm to lower

**Ackerman bar flipped and lower 2mm

Front wing fitted

camber -1

Toe in/out 0

Rear

25w
Spring AE sliver
Piston 3 hole taper drilled to 1.2 all round
Shocks set to 90.5 over all length
4 internal spacers and 4mm external limiter
**New Inner hole drilled on shock tower
**New inner hole drilled on wishbone
Wishbone set backward * trimmed
Hubs set forward ** trimmed for shorter wheel base
**Rear roll bar fitted bar at 0.90.
Camber link set at Inside low on Hub
Camber link set to outside high on tower ** new hole pick up bracket moving pick up 3mm shorter
No Gurney on wing, but wing set forward

Camber -2
Anti squat 3 deg
Toe in 4 deg

40g lead under servo
60 G of lead in speedo. receiver tray
21g in each of the small pockets at rear of chassis next to motor
Crush tubes fitted all round in hubs
Wide rear wheels and narrow front wheel fitted on high grip tracks
Inserts from inside line racing - Donutz Blue all round
Tyres Schumacher mini pins all round, no rows cut