Lazy GOOOoooooo- Few Q's....

[jamiekerr14]

Ello All...

Finally got me some Lazy GOOOOoooooooooo

I have done the usual-Put some round the rx+Sensor leads at the ends.. and round the Tekin RS Pro Case seam. I was wondering a couple of thing's, I know that you should not cover the solder post's with heat shrink or anything as there are another part of the cooling. But can you put on some lazy goo? a very thin coat.. to keep away any moisture ect.. but still keep them relatively uncovered? That possible.. and some for the ends on my Bannana connector's? on the top-by the solder and wire meets ect...


Just wondering these 2 things.. specially now with the wet weather wondering if it's possible instead of the occasional bluets!