CAT SX One-Way Pulley Problem

[inferno_4wd]

Hi Guys,

Once again i need your help. I failed to land my CAT SX from a big jump and it took a heavy impact, since then my one-way pulley moves both ways!

I've taken it apart and found that the bearing is actually slipping inside the pulley, with the bearing removed from the pulley i've put it on the shaft and the one way bearing itself is working fine, it locks in one direction as it should so the problem has to be that the bearing isn't fixing into the pulley properly.

Should this bearing be able to come out and maybe it's a case that something isn't done up tight enough or is it normally glued in place at the factory?

Anyone else had this problem?

Thanks, Nick