|
||
|
 |
|
||||||||||||||||||
|
#1
16-09-2009
|
||||
|
||||
Iffy Diffy
Hi Guys
Just went to rebuild my diff on my cr for my cr2 conversion. Its had almost a total new diff... New Diff plates New thrust race New diff gear New vampire diff balls New diff nut. Only thing that is still out of the old diff are the outdrives diff screw, bearings and spring. I built it as i normally do but when i tighten it i have to tigten it alot to set it right and when i finally get it to the stage where it is right the diff action is tight and not smooth. HELP!!! Any Advice welcome. A
__________________
Ashley Williams I always thought by 2013 we would have flying cars, but we have got blankets with sleeves! Last edited by ashleyb4; 17-09-2009 at 10:03 AM. Reason: Corrected some of the england 
|
| Thread Tools | |
| Display Modes | |
|
|
Team Losi Racing
Threaded Mode