LRP Sphere TC positioned behind motor. 501x.

[jhammond]

I was wondering if anyone had any images of how they have orientated their LRP Sphere TC, when running it behind the motor; I have searched on the forum, but everyone seems to run it behind the servo. (I would rather not as I don't have a low profile servo, and it seems more logical not to run 5 wires through the centre bulkhead.) I know there must be a few people who also run it behind the motor though; even if they are a minority.

I know it's going to be a tight fit, but I can't decide which way to position the ESC.

(I'm still waiting for my ESC to arrive. But would like to see some images if there are any out there.)

I presume the best way would be to have the wiring tabs on the ESC facing towards the rear of the car, and then run the motor ABC wires so that they are soldered through the tabs from inside to out. (So that the end of the wires are at the very rear of the motor can; facing away from the pinion.) And then rotate the motor can so the tabs are faced to the front.

Any help would be much appreciated.

Thank you.
[/FONT]