Right, but did you reset the setting in the way the upgrade instruction pdf tells you to? The old setting for the old version are incompatible with the new ones so you have to blank it and reset it all up.
Quote:
Originally Posted by JackWood
Got the software working OK. Had to get the USB drivers off the disk though. Did do a fresh install. Just think it got its knickers in a twist with AVG etc
All that works now.
However, if I upgrade to 128 I get no consistent reverse, but everything else works well. Tried callibrating with the transmitter over 10 times, and still no joy.
If I swap back to 125 firmware everything works fine again, like it did before. As soon as I go up to 128 I lose the reverse. Sometimes it comes on if you bang the stick back, but most of the time it just goes to brake.
I think it must be to do with the breaking modifications they made with this firmware, and it is like there is now not enough stick travel to get it to reverse. I don't know.
I am back running 125 for now while I'm bashing around, but the spike voltage cut-out is annoying.
|
14-01-2009
Threaded Mode