Quote:
Originally Posted by DaveG28
The higher the grip of the track the better the 0 degree hubs work, on grass it was very good, on dirt and in the wet I've struggled.
with the shocks, I can't tell the drill bits from each other, but I'm hoping I'll be ok with roughly 1.3mm rear holes (whichever Losi drill is closest to that I used) and one size smaller at the front. No spares so screwed if their too big!
Jimmy, I used Tamiya shocks at the first regional, you'd need to change spacers etc on the top mount to make it work right (I had them at an angle and bent three shock shafts!) but its much better than pre-fixed Aero ones!
|
Dave, 1.3mm is close to a 55 hole (slightly smaller i think) so it won't be far off. I just feel it works better with 56 (1.2mmish).
This is a table showing you the drill size dimensions in inches
http://www.gcrossett.com/zipzaps/tech/drill_bits.htm
02-05-2008
Aero Racing
Threaded Mode