last bits

[hammerhead]

right this is it every last morsal i have of anything rc im looking to sell this as a job lot as cba with splitting
various clutch shoes/springs
brand new vented 12 clutch bell with bearings
1 taxxas revo clutch shoes and bell with bearings
3 flywheels
1 clutch bell 17 with bearings
10 clutch bearings bnip
fly wheel removal tool
1 muggy 1pc mount
1 failsafe
1meter of fuel line bnip
1 flatpack 1500mah used but holds its charge
1 hump pack 1500 mah used but holds its charge has had tape around it as was at on outside of my savage
variouus body pins
1 losi rotor start with backplate and 1700mah battery
1 metered glow start 3300 mah battery used about 5/6 times with charger
1 set of 17mm hex hubs no bolts on them tho
7 glow plugs unsure what make all varied all tested and work fine
3 servos nothing special will do for throttle ms-x7(hpi) ks-102bk (kyosho) h-101 (hobao)
2 fuel bottles
1 full center difrential for a muggy 48t i think
after run oil near full
air filter oil half full
shock oils 20wt full 25wt near full 40wt half full 30 wt 3/4 full
futaba neck strap
box of force engine spares ( carbs backplates and cooling heads)
£40 posted the lot
and if i dig up anything else along the way will throw in also

ALL SOLD!!!