Nosramm matrix istc stock spec troubles

[aH0tUnicorn]

Hi,

i recently brought this off someone and im having a though problems setting it up.

I have soldered it to my orca 6.5 and was wondering but when every i throttled i would brake and it wouldnt work when the setting is at 100% and it would just throttle when i didnt press it.

ive looked at the manual and done all the settings but now its stuck in a wired mode and wont work. the mode button is red and when ever i hold the set button it will shut down.

Thanks

[aH0tUnicorn]

Can anyone help me as im still having problems. Ive been having lots off problems with electrics recently and need to get it sorted.

Thanks

[Hog]

1 - Reverse the throttle setting on your transmitter.
2 - Set the throttle end points to 150% on your tranny.
3 - Recalibrate the ESC (reset neutral, full throttle and full brake).

I run a couple of Nosram ESC's in my and my kids SC10's and have had to reset the throttle settings and recalibrate on all mine. Pretty sure you should get a blue light on the ESC when you're getting full throttle.

[aH0tUnicorn]

Hi Hog,

Thanks for that as i think that should do it but ill try it when i get home. The speedo keeps cutting off when i press the set button for 3 seconds and their is a red light on the mode light.

Thanks

[Hog]

Sounds right to me - when you're entering the setup mode the speedo will stop working while you're setting the end points.

Press the setup button for 3 secs and I believe the red light will flash. Press the set button to establish neutral. Press full forward on the tranny and then press the set button again. Pull full back on the tranny and again then press the set button to get full brake. Let your throttle on the tranny go back to neutral and give the speedo a second or 2 to settle, and then you "should" have your settings stored and a fully functioning speedo.

[aH0tUnicorn]

Okay thanks hog ill try that when i get home.