xray t3 2012 problem

[moggy12]

hi to all i recently bought and built t3 2012 to replace my t3 2010 all seemed ok when i went to my club night i race on indoor carpet i drove car down straight slowly to check to see if steering was straight it was ( i set car up on setup guages before hand ) but when i started to go faster in practice on full throttle car was veering of and had to keep steering on radio to keep car straight apart from this car is great but i was 1-2 laps faster with my t3 2010 then this one due to the car veering of slightly down the straight any ideas ? car is set up for carpet as in manual 25 % shock rebound thanks
hi to all i recently bought and built t3 2012 to replace my t3 2010 all seemed ok when i went to my club night i race on indoor carpet i drove car down straight slowly to check to see if steering was straight it was ( i set car up on setup guages before hand ) but when i started to go faster in practice on full throttle car was veering of and had to keep steering on radio to keep car straight apart from this car is great but i was 1-2 laps faster with my t3 2010 then this one due to the car veering of slightly down the straight any ideas ? car is set up for carpet as in manual 25 % shock rebound thanks

[roboliver]

i would a check servo ,b check tire diamaters and mack shre of even size,b check and see if you dont have a bearing ahging in hub or right wheel crushing bearing or just too to tight ,make sure steering beel crank is free and not to tight also if not then look at rebuilding front diff and seeing if theres a error there
hope theeses ideas help

[dale]

Could be a dozen different things, including tweak, binding suspension, uneven rear toe, binding bearings, tight driveshaft, binding steering, incorrectly assembled servo saver, faulty servo, uneven front steering rod lengths, incorrect front toe etc.

Take the car to one of the quick drivers at your track, they will probably spot the issue pretty quickly.

[moggy12]

thanks guys for info car was still not very good at last night club night so stripped car down when i got home did find rear drive pin was sticking out one one side catching the rear hub slightly so sorted that could this be the causing the problems i have been having ?

[smarkham]

May have been contributing to it my old t2 had a few strange problems that turned out to be a seized bearing in one of the rear hubs.

[anthonybirch1983]

Glad you sorted it! I had a similar problam and that too turned out to be pin related too......