FrSky 2.4 module in 3VC

[john333]

Hi everyone,
I've just ordered a FrSky module and receiver from Giantcod, and was wondering if anyone else has fitted one to a Futaba 3VC?

Not had it yet so can't read the instructions but apparently it's just a case of soldering 3 wires (pos, neg and PPM feed)

My question is where will I find the PPM feed in my transmitter?

[knighthawk]

I was thinking of this for converting my two lads to 2.4
as they both have the 3VC TX's

Just went onto the FrSky website and downloaded the manual
and its basically plug n play like the Futaba 2.4 units

All you have to do is make sure the TX is in PPM mode which is in the
menus under MOD ( either PPM or PCM )

http://www.frsky-rc.com/uploadfile/2...9145903307.pdf

What units did you buy ?

[john333]

Hi, Can't put my fingers on the unit part numbers I ordered, but it is the "hack" module ie the one that goes inside the tranny rather than the plug in box. It appears to be hard wired into the tranny

[knighthawk]

http://www.frsky-rc.com/uploadfile/2...1122214895.pdf

This one then

[john333]

Thanks nighthawk, much obliged ;-)

[rondoolaa]

hi,

if you want 2.4 in a 3vc or 3vcs you cant go cheaper than this,

i have these in both my 3vcs's and purchased extras so i can use the recievers in my other cars and have spare transmitter modules....

http://www.ebay.co.uk/itm/Corona-RC-...item3a70a7893e