ribs vs Staggered ribs vs minipins

[Bluestreak]

Ok guys so I've been advised by a few people about front tyres for my 2wd cobra (that currently has too much front grip), to use either Ribs, staggered ribs, or mini pins. Car will be raced indoors on carpet.

So I thought I'd throw it open to everyone to ask what are the relative merits of these types of tyres as I'm getting a few conflicting suggestions at the mo. This is obviously ment with no disrespect to the guys who have already offered advice as all is gratefully recieved. I just thought I'd get as many opinions as I could at the mo.

Car currently has dBoots Terrabytes on the front which are just too aggressive.

thanks in advance for all input

Ash

[jamiekerr14]

I would rate them in Aggressive to least

Terrabytes
Mini Pin
Cut Stag
Stag

Most use Stag's or cut stags up front if you need a tad more front end. But generally staggers are used. As there a safe bet, and can be more consistent to drive. A lot depends on driver and how the car is set up. I Prefer cut stagger's personally but I like to have a fair bit of front end. But some people prefer the opposite. Its all preference tbh..

[Bluestreak]

Thanks Jamie. Just out of interest where would you put full ribs such as proline. Im assuming between cut staggered and mini pins

[jamiekerr14]

Um, I would put the Proline ribs at the bottom. I have never tried them but think they are too soft and don't dig in for astro use personally. But there good for the U.S. and dirt.

Terrabytes
Mini Pin
Cut Staggers
Staggers
PL Ribs

Thats the order I would put them in.

[Bluestreak]

Ok thanks Jamie

[lardy37]

not raced 2wd on carpet but i would say mini pins most grip then cut staggered then staggered and probably ribs with least grip but thats not to say they wont be good for carpet