Servo saver block in Dex410

[eNick]

Hi,
In some side position of steering the saver function of servo saver is blocked by servo body. Marked by red arrow on the picture below.

I.e. steering works but red part of servo-saver can't go down therefore saving functionality of servo saver does not work.
How to solve the issue ? Appreciate any comments and advise.

[Andyp]

Place the whole lot on a flat surface and loosen the 4 screws that hold the servo in , put abit of pressure down on the servo to make sure it is hard against the flat surface then re tighten , if you understand what I mean this should give you the extra 0.5-1mm extra clearance you need.

It's making sure the servo is flat against the chassis.

Hth

[eNick]

Hope I understand. Thank you very much Andyp. I guess that was the reason of servo arm "teeth brake off".
Will try in the evening and reply.

[eNick]

Followed the advice from Andyp and now the gap is 1-1,5mm. Hope it is enough.

[coleman758]

+1 Just make sure the servo is in line with the bottom of the mount.

I have the same servo and its never been an issue

[eNick]

Originally Posted by coleman758

+1 Just make sure the servo is in line with the bottom of the mount.

Servo is in parallel with bottom but I can't make it to touch bootom. It has very few space (less than 1mm) between bottom and servo body.