|
|
#1
|
|||
|
|||
![]()
Whats the best liquid mask? And where can I get it in the uk? Cheers
|
#2
|
|||
|
|||
![]()
I personally really like RCS liquid mask from Jon Miller (rcsgraphicworx) it goes on nicely and peels off a treat.
There are others such as Fasmask which is ok and Bob Dively (incredibly hard to get hold of over here but also heard really good things about) If I were you I'd get the rcs stuff, either from xfactory (distributor), or order through your local hobby shop or through the rcs website. ![]() |
#3
|
||||
|
||||
![]()
Thanks Piggy D!
![]() On a side note, I have sold my soul finally and started a facebook page. haha. Feel free to stop by for various offers and news etc http://www.facebook.com/RCSGraphicWorx |
#4
|
||||
|
||||
![]()
I'll echo what's been said above, top quality mask, best way to do this sort of painting !
@ Jon - Facebook.... you sell out ![]() ![]() |
#5
|
||||
|
||||
![]() ![]() ![]() |
#6
|
||||
|
||||
![]()
I recently used the RCS mask for the first time, I put down 4 coats leaving a day between coats to dry, when I cut the mask last night it started splitting along the cut lines and leaving gaps about .5mm wide... almost like it was stretched, so I have had to peel it off and start again, I washed the shell thoroughly with warm soapy water and dried it with a lint free cloth etc... Is there any reason why it could have done this ?
It has been kept in the house not the shed so it's not frozen at any point or anything daft like that and I gave it a good shake before applying to make sure it was mixed... I'm at a bit of a loss to think what went wrong ![]() Any thoughts ? Cheers, Aaron. |
![]() |
Thread Tools | |
Display Modes | |
|
|